How do I troubleshoot OneMira C1?
Resolve C1 power, pairing, Bluetooth, USB, local ASR model, MCP client, battery, and sync issues with observable checks and recovery steps for each issue.
How do I fix hardware and connection issues?
Why isn't my device found during pairing?
While powered on, press and hold the side button for 3 seconds. Release after the white LED lights up to enter pairing mode; the white LED flashes for 60 seconds. Wait until the app and C1 both show the pairing status. If C1 does not respond, make sure it has power and Bluetooth is enabled on your computer. Keep the device within about 5 meters during pairing and sync.
Why is Bluetooth permission denied?
Open your operating system's Bluetooth privacy settings, ensure the OneMira app has permission, then restart the app and try scanning again.
How do I perform a force reset?
If the device becomes frozen or unresponsive, you can perform a force reset by power-cycling it: press and hold the Multi-Function Button for 8 seconds to force power off, and then press and hold for 3 seconds to power it on again.
Note: If the USB-C cable is connected, the LED indicator will turn off during the reset and reboot process.
How do I update firmware?
Firmware update details are shown in the desktop app when an update is available.
How do I fix software and AI issues?
Why is my device connected but not transcribing?
Ensure capture is active in the app. Press ⌘ R in the app or short-press the side button to start capture. Also check that the transcription engine has been deployed in the setup flow.
Why does the ASR model download fail?
Check your internet connection. Typically 100–500 MB depending on the model. Click "Retry Deploy" to resume. The download will pick up where it left off.
Why isn't my AI tool detected after setup?
Some AI tools need to be restarted after config changes. Close and reopen the AI tool, then call Mira again through its MCP tools, slash commands (such as /mira-search), or tool references (such as @mira_search) depending on your AI client. You can also go to Settings → MCP → Rescan to verify the configuration status.